![]() To connect your Station Pro to a network: If you offer Wi-Fi access to your customers, follow the best practice and give them a different Wi-Fi network to use. Your network needs to be a closed, protected, secure network to process payment transactions. If you plan to connect to a network using Wi-Fi, check to make sure your router is set up, connected to the network, and has a security level of WPA or WPA2. There are three ways to connect your Station Pro to a network: Ethernet (recommended), Mobile (SIM) card, and Wi-Fi. Connect your Station Pro to a networkĬonnect your Station Pro to the network after you assemble it. Next, connect your Station Pro to a network. There are no power buttons, but there is a reset button on the reverse side of the customer-facing terminal screen in case you are ever instructed by Customer Support to use it. The (smaller) terminal automatically powers on first, and then the (larger) display. Your system is now connected and you can place each device right side up. Plug the other end of the power adapter into your power source for the system.Pick up the power adapter, sometimes called a power brick, and plug one end into the hub, as shown.Pick up the hub and use the screwdriver to connect its cable to the base of the display, as shown.Unwind the printer cable from the printer base and use the screwdriver to connect the printer cable to the base of the display, as shown.Screw in the screws with hand-tight pressure, in other words, just hard enough to secure each screw and also be able to unscrew it later if needed. ![]() Plug in and connect the other end to the base of the terminal, as shown.Use the supplied screwdriver to connect the end of the cable with the green arrows to the base of the display, as shown.This cable has two small screws in both ends and one end has a green arrow. To connect the parts, follow the numbered steps here and above: You’ll be looking at the bases of all 3 devices and the printer will be in the middle. Place the Station Pro Terminal, screen side down, next to the printer.Place the Station Pro Printer upside down next to the display.Gently place the Station Pro Display screen side down on a clean, flat surface.Start by getting ready to connect the parts. After all the parts are connected, you can plug it in. Put together your Station Pro by connecting all the parts. Contact your merchant supplier for details.) (Shipped with the Station Pro in some regions, and available everywhere. The optional PIN Shield sits on top of the terminal and gives customers added privacy when they enter their PINs. This option assists customers who have difficulty using a touchscreen. The PIN Entry Aid sits on top of the terminal. ![]() The receipt paper roll goes into the printer. The LAN Ethernet cable connects the completed assembly to your internet network. The power cable connects everything to the power source. The power adapter connects the assembled system to the power cable. The hub connects the terminal and the display to the power adapter. The connector cable connects the terminal to the display. The screwdriver helps you connect all the cables for easy assembly. The printer prints a paper receipt on demand. The terminal faces the customer, accepts payments and signatures, and has a headphone jack and speaker on the reverse side of the screen. The display faces you and takes order input.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |